Hot Water Booster

Series HTC heaters include a formed nickel-plated copper Glenn tubular heater mounted to a finished steel control housing. A heavy duty spash resistant thermostatic control equipped with a manual reset over-temperature cutout has a positive on-off switch.
An integrally mounted pilot light inducates when off that the water had reached desired operating temperature. All heat has been concentrated in the lower portion of the element permitting low water levels, but this portion must remain immersed. A fully adjustable stainless steel mounting bracket is attached to the cold risers for mounting on the splash board or tank rim.
All internal wiring is complete, terminiating with a three conductor 3' cord set and standard appliance plug. No contractor is required, except a properly switched and fused power supply.

Glenn Hot Water Boosters have been primarily designed for water immersion applications as found in restaurants, confectioneries, and ade stands. The adjustable thermostat permits selection of water temperatures to meet local health department sterilization regulations.
The stainless steel models (HTT) are ideally suited for electroplating, foor processing, cosmetic blending, degreasing, and many other applications requiring a reliable source of portable heat.

• No installation required.
• Indicating know and pilot light.
• Portability permits complete cleaning of tank or compartment.
• Adjustable for various compartment or tank depths.
• Temperature range of 60-250 degrees F, with an operating limit at 215 degrees F.
• Three conductor cord set with polarized plug.
• All heat in lower portion permitting low solution levels. Liquid level must be maintained over heated section: Never Operate Out Of Liquid.